THE EFFECT OF THE SCRAPER’S INSTALLATION ANGLE RELATIVE TO THE HORIZONTAL ON THE PERFORMANCE OF THE DISC PLOUGH
Abstract
In these experiments, the following parameters were set: the curvature radius of the scraper’s working surface was 30 cm; its installation angle relative to the horizontal was 20°; its installation height relative to the center of rotation of the disc body was 15 cm; the length of the working surface was 30–35 cm; the tillage depth was 25 cm; and the forward speed of the aggregate was set at 6 and 9 km/h.
References
1. Tukhtakuziyev A., Ishmuradov Sh.U., Abdumajidov, R.B. Researching the parameters of the disc plough and its smooth run throughout the tillage depth // Iop Conference Series Earth and Environmental Science, 2021, 868(1), 012058
2. Ishmuradov Sh.U., Abdumajidov R.B. Influence of The Angle of The Device (Scraper) to The Horizontal on The Performance of The Disk Plow// Pindus journal of culture literature and elt – USA, Vol. 5 No. 5, 2025. – P. 12-16.
3. Ishmuradov Sh.U., Abdumajidov R.B. Influence of The Radius of Curvature of The Working Surface of The Device (Scraper) on The Performance of The Disk Plow// Pindus journal of culture literature and elt – USA, Vol. 5 No. 5, 2025. – P. 15-12.
